SEARCH TELATOMIC

PO Box 924, Jackson, MI   49204       1 (800) 622-2866

HOME

POWER SUPPLIES
INTRODUCTION | FINE BEAM TUBE | PLANAR DIODE | PLANAR TRIODE | GAS-FILLED (HE or NE) PLANAR TRIODE | MALTESE CROSS | LUMINESCENT TUBE | PERRIN TUBE | THOMSON e/m TUBE | HERTZ TUBE DATA ACQUISITION SYSTEM | ELECTRON DIFFRACTION TUBE | CLASSICAL ELECTRON PHYSICS SYSTEM | TUBE ACCESSORIES

TEL GP-3403D TEL-GP4303D Power Supply
The 0-30V 3Amp low-voltage power supply is lightweight, compact and easy to carry. It has a built-in output current limit circuit and a 4 digit green LED digital display for both current and voltage. Ripple is less than 1.5mVp-p.

SPECIFICATIONS
Output voltage: 0 - 30V continuously variable
Output polarity: Positive and Negative
Output current: 0 - 3A
Ripple voltage: Less than 1.5mVp-p
Output stability: Less than 5mV for power source voltage change of + 10%, less than 5mV for load variation of 0 to 100%
Volt meter accuracy: + (1% + 1 digit)
Ampere meter accuracy: + (1% + 1 digit)
Insulation: Between chassis and output terminal : More than 10MW at DC 500V, between chassis and AC plug : More than 50MW at DC 500V
Compensation/Protection circuit: Overload protection circuit of constant self-restoring type
Ambient temperature range: 0 - 40° C
Power source: AC 110/220V, 50/60 Hz
Dimension (W x H x D): 131mm x 143mm x 253mm
Weight: Approx. 4kg
Accessories: Short-circuit bar x 1, fuse x 1

Use with TEL 2502 Helmholtz coils and a filament supply for TEL2533 Hertz tubes.

TEL-GP4303D $229.00



U8521371
 

TEL U8521371 DC Power Supply
DC Power Supply Unit 0-300 V, Tube Power Supply Unit for experiments with cathode ray tubes. With the adjustable voltage, that increases or decreases linearly with time, it is also possible to conduct additional experiments on the law of induction and on the charging and discharging of capacitors. The DC voltages 0 - -50 V and 0 - +300 V have a common zero point, so DC voltages of up to 350 V can be tapped.

SPECIFICATIONS:
Operating voltage: 230/115V AC, 50 (60) Hz
Output voltage: 4 to 12V; 400 mA
0 to -50 V; 10 mA
0 to 300V; 200 mA
Ramp generator (linear gradient): 2.5 to 50 V/s
Dimensions in mm (L x W x H): 240 x 230 x 170
Weight: approx. 3.7 kg



TEL U8521371 $922.00



 
 

TEL EV11M Power Supply
Two separately-regulated, independent supplies provide 0-500 Vdc at 10 mA, 0-50 Vdc at 10 mA and filament voltage taps supplying 1, 2, 3, 4, 5, or 6 Vac. A 7.5cm panel monitors the high voltage. All supplies float relative to ground and interconnect in any order desired.

SPECIFICATIONS
High Voltage: 0-500 Vdc @ 10 mA
Regulation: +/- 4% for line @ load limits
Low Voltage: 0-50 Vdc @ 10 mA
Ripple: 4% of setting, maximum load
Meter: high voltage on 7.5 cm panel meter
Heater Voltage: 1, 2, 3, 4, 5, or 6 Vac @ 1A
Ground: floating grounds, supplies connect together as desired
Connections: eight 4mm banana jacks



TEL EV11M $525.00



TEL 2811 HiVoltage Bias
A low power high voltage supply required for use with TEL 2525, and TEL 2524 tubes. A regulated voltage of 0-350V max: 0-50V is continuously variable, then 6 add on steps of 50 volts. Regulation is 1% @ .5 mA max and 10% @ 5mA max. Includes TEL 2014 power plug.
TEL 2811 $522.00



TEL TEL EV-14 Kilovolt Power Supply
Safe, accurate high voltage. Designed for high voltage requirements in the student laboratory, this power supply is safe, sturdy and reliable. Shielded banana jacks provide the 5 kilovolts output from the rear panel, safely away from hands. A digital voltmeter displays the output voltage for greater accuracy than the usual analog meter. We provide a 6.3 Vac filament supply on the rear panel. The output current is limited for safety. Especially useful with Teltron tubes and electrostatic experiments.

SPECIFICATIONS
Voltage: 0-5 kVdc, 6.3Vac filament output
Output Current: 1mA at 5000 Vdc
Line Regulation: >1% for 10% line voltage change
Load Regulation: 3% for 0 to 500mA
Ripple: 0.2% at maximum current
Meter: three 1.4 cm high digits on front panel
Connections: color-coded 4mm high voltage insulated banana jacks
Dimensions: 9.5 h x 26 w x 22 d cm (3.8 x 10 x 8.5 in)

Use with TEL 2525 Thomson e/m tube and TEL 2555 Electron Diffraction tube.

TEL-EV-14 $725.00


Need technical information or to place an order?
TEL-Atomic     1-800-622-2866
Teltron
Products

Tel-X-Ometer X-Ray
  & Accessories
Electron Tubes

Spectroscope

Thermodynamics
Radiometer
Leslie's Cube
Stefan-Boltzmann
Nuclear
Systems

Multichannel Analyzer
Counters
Basic Systems
Advanced System
Isotope Generator

Spin Resonance
Systems

Pulsed NMR
Advanced NMR/ESR
Other Products
Kater Pendulum
Photogate
Air Tracks
Oscilloscopes
Instrumentation
  Sweep Generator
    with Counter
  Multimeters
Superconductivity
Photoelectric Effect
Cloud Chamber
Planck's Constant
Cavendish Balance
Rutherford Scattering Apparatus
Speed of Light Apparatus
Magnetic Bubble Apparatus
Millikan Apparatus
Smart Magnetic Sensor
Power Supplies

Warranty, Freight & Terms     Contact TEL-Atomic
sales@telatomic.com